Academic & Science
ECSS Full Form - What is Full Form of ECSS?
What is Meaning of ECSS?
ECSS full form is Exalted Carrier Single Sideband.
What is Exalted Carrier Single Sideband?
This technique (often abbreviated ECSS) depends on the receiver's selectivity as well as being able to select one sideband or the other.
The basic procedure involves tuning an AM signal in sideband mode. Tune it until the signal has no tone on it (this is referred to as zero beating the signal) This generates 2 signals - one lower than the the original frequency, one higher. Either using the BFO or a synchronous detector, you tune away from the interference by selecting one sideband or the other. You would then use other controls (if available) to further clean up the signal. Tuning like this can be reported as ECSS-U if you were listening on the upper sideband, or ECSS-L if listening on the lower.
ECSS Full Form - What is Full Form of ECSS?
What is Meaning of ECSS?
ECSS full form is Exalted Carrier Single Sideband.
What is Exalted Carrier Single Sideband?
This technique (often abbreviated ECSS) depends on the receiver's selectivity as well as being able to select one sideband or the other.
The basic procedure involves tuning an AM signal in sideband mode. Tune it until the signal has no tone on it (this is referred to as zero beating the signal) This generates 2 signals - one lower than the the original frequency, one higher. Either using the BFO or a synchronous detector, you tune away from the interference by selecting one sideband or the other. You would then use other controls (if available) to further clean up the signal. Tuning like this can be reported as ECSS-U if you were listening on the upper sideband, or ECSS-L if listening on the lower.
ECSS Full Form - What is Full Form of ECSS?
What is Meaning of ECSS?
ECSS full form is Exalted Carrier Single Sideband.
What is Exalted Carrier Single Sideband?
This technique (often abbreviated ECSS) depends on the receiver's selectivity as well as being able to select one sideband or the other.
The basic procedure involves tuning an AM signal in sideband mode. Tune it until the signal has no tone on it (this is referred to as zero beating the signal) This generates 2 signals - one lower than the the original frequency, one higher. Either using the BFO or a synchronous detector, you tune away from the interference by selecting one sideband or the other. You would then use other controls (if available) to further clean up the signal. Tuning like this can be reported as ECSS-U if you were listening on the upper sideband, or ECSS-L if listening on the lower.